Fibaro Roller Shutter 2 (Z-Wave)

Roller Shutter is a roller blind controller compatible with Z-Wave network. Roller Shutter module allows to control and position roller blind motors.

Roller shutter module can handle up to:

• 4,2 A for lamps and resistive loads
• 1,7 A for motors with compensated power factor (inductive loads)

Generally no – Roller Shutter is designed to be connected directly to roller blind motor.

In fact no. DC motors uses different control technology so it cannot be controlled without additional executive circuit.

Yes you can – use association functionality and control up to 15 roller shutter modules from only one module.

If you use Home Center 2 or Home Center Lite you can associate 15 Roller Shutter modules but it is not recommended to associate more than 10 devices in general.

Yes – these roller blinds are fully compatible with our roller shutter module.

You can control such roller blinds but it will not be possible to position them. To control such roller blinds please modify parameter 10 for value 1.

You should use proper block according to your device’s name. For example for A2 roller shutter will be following block:

You can enter desired open level in green box (45% for example). Red box is used for defining delay (10 seconds).

Probably you have roller blinds with electronic limit switches, please modify parameter 10 value to 1.