Fibaro Swipe Gesture Controller (Z-Wave)

FIBARO SWIPE is a scene controller, each gesture can control multiple devices at the same time and when you trigger scenes the only limitation is number of devices used within a scene.

There are four (Up, Down, Left, Right) basic gestures. In addition you can enable circular gestures in parameter 10: circle right, circle left. You can also use 6 combinations of basic gestures. Max. 12 gestures and combinations can be used.

SWIPE can work through any non-metallic material: wood, drywall, stone (granite, marble), also glass (single layer), laminate and any synthetic material. It will not work through metal or mirror. Thickness may vary depending of material type.

Max distance is about 5 cm (2”).

10 x 15 cm (6 x 4 inches).

4xAA batteries and/or micro-USB.

Sound sequence – enter/exit MENU mode
One short beep – device wake up
Two short beeps – learning MODE
Three short beeps – device RESET

Double beep during gesture – valid gesture/combination confirmation
Single long beep during gesture – invalid gesture/combination

Any Z-wave device, virtual device or any device included in any kind of scene can be assigned to one of the gesture/combination.

Sonos or any TCP/IP device can be controlled using Virtual Device buttons or scenes using available LUA commands.

SWIPE can trigger Z-wave actuator or Z-wave relay connected to an actuator to open or close the window.

You can create a scene to arm/disarm alarm system and use a SWIPE to trigger it. Combination of 2 or 3 gestures can be used to trigger an alarm scene.

Yes, you need to create a Lua scene to do so.

SWIPE is always on when has micro-USB connected.
It has 2 powering modes:

1. Battery powering mode (preserves battery life): device needs to be awaken before gesture by moving hand close to the center
2. External power supply mode: constantly detects gestures.

Device may be in battery powering mode and needs to be awaken before the gesture or first gesture wasn’t done close enough.

It depends how often you are going to use the device. SWIPE’s battery life on default settings is like typical remote control.

SWIPE can be powered using 4xAA batteries and/or micro-USB 5V.

• Each sequence must be unique
• Sequence can consist of two or three basic gestures (left, right, up or down)
• Two identical gestures cannot be used next to each other

Remove the front picture cover and use double sided tape or Velcro to attach the device to horizontal or vertical surface. Make sure surface you want to mount SWIPE is clean of dust or grease before you apply any type of mounting material. Do not overuse mounting material to make sure you can easily remove it without bending or breaking any SWIPE parts.

Beeps may indicate validation of gestures, menu, entering/exiting standby mode or any interference with metal materials like cables, metal re-bars, etc.

Buzzer may indicate successful or failed gesture recognition. You can decide which one you want to have signaled or disable the buzzer.

SWIPE can be powered directly using micro-USB without using the frame.